Setting A Single-Character Label Id - Intermec SR60 Programmer's Reference Manual

Chapter 3 — Configuring Label Transmit Settings
MSI/Plessey
END ------------------------------------------

Setting a Single-Character Label ID

62
---------
The scanner does not transmit a label ID character if its hex value
is set to zero. If you need a Label ID that contains only a single
character, you can set a single-character label ID.
To set a single-character label ID
1 Using the ASCII chart on page 158, identify the ASCII
character and the corresponding hex code for the single-
character label ID.
For example, suppose you want to change the Label ID for
EAN-8 from the default setting FF to the single character 8.
The ASCII chart shows that ASCII 8 equals 38 hex.
2 Scan the SET bar code on page on page 58.
3 Using the bar codes in "Selecting the Symbology" on page 58,
scan the bar code representing the symbology whose Label ID
you want to change.
For this example, you would scan the EAN-8 bar code.
4 Using the list of bar codes that starts on page 154, scan the
two digits corresponding to the hex value you chose in Step 1.
5 Scan the 0 digit twice to disable transmission of a second
character.
For this example, you would scan 3, 8, 0, and 0.
Note: Successful programming requires four digits for the
label ID.
SR60 Scanner Programmer's Reference Manual