Scanner Beeper; Integrating The Scanner With Your Host System - Intermec SR61T2D Programmer's Reference Manual

Chapter 1 — Learning About Programming the SR60 Scanner

Scanner Beeper

Integrating the Scanner With Your Host System

8
The green Good Read LED is located on top rear of the scanner
and flashes:
• once to indicate when a good read has occurred.
• slowly on and off to indicate the scanner is in Programming
mode.
The beeper operates differently when the scanner is in Scanning
mode and in Programming mode.
• When the scanner is in Scanning mode, the beeper sounds:
• four times at power-up.
• once following a good read.
• six rapid chirps to indicate an error (error tone).
• When the scanner is in Programming mode, the beeper
sounds:
• once when entering or exiting Programming mode.
• three times to indicate a successfully programmed feature.
• an error tone if you scan programming bar codes for
features that are not compatible with the current interface.
For example, you can set baud rate and parity only when
the current interface is RS-232.
Your scanner must be equipped with the correct hardware to
properly communicate with your host system. Contact your local
Intermec representative if you have questions about your scanner
hardware compatibility.
Intermec offers the following interface cables for the SR60
scanner:
• Laser emulation
• Wand emulation
• RS-232
• Keyboard wedge
• USB
SR60 Scanner Programmer's Reference Manual