Chapter 5 — Configuring General Features
Configuring the Green LED Idle State
SET-------------------------------------
LED Off
LED On
END------------------------------------
Configuring the Beeper Settings
140
You can program the green LED to be either On or Off to
indicate that the scanner is idle.
---------
---------
You can configure the audible beep signal using these
programming bar codes:
• The Beep On on page 142 and Beep Off bar codes on
page 141 enable or disable the beep upon completion of a
good read.
Note: Intermec strongly recommends that you do not disable
this feature. The good read beep provides the best scanning
status feedback to the user. You cannot disable error tones.
• The Power-up Beep Enable and Disable bar codes on
page 142 enable or disable the audible tone at power-up.
• The Beep Volume bar codes on page 142 let you set the
beeper to three different volume settings.
SR60 Scanner Programmer's Reference Manual