Table of Contents
Advertisement
Chapter 3 — Configuring Label Transmit Settings
Setting a Prefix or Suffix for a Multi or Decoded Interface
58
Use this procedure to set a prefix or suffix that has only one
character.
Do not use this procedure if you have a USB interface. For
a USB interface, see "Setting a Prefix or Suffix for a USB
Interface" on page 54.
To set a prefix or suffix that has only one character
1 Using the ASCII table on page 164, identify the ASCII
character and the corresponding hex code for the single-
character prefix or suffix.
For example, suppose you want to use the Space (SP)
character. The ASCII charts shows that SP equals 20 hex.
2 Scan the SET bar code on page 59.
3 Scan the Set Prefix or Set Suffix bar code.
4 Using the list of bar codes that starts on page 160, scan the
two digits corresponding to the hex value you chose in Step 1.
5 Scan the 0 digit twice to disable the transmission of a second
character.
6 For this example, you would scan 2, 0, 0, and 0.
Note: Successful programming requires four digits for the
label ID.
Note: If you make a mistake or lose your place while setting
this option, scan the END bar code to exit Programming
mode. The scanner sounds a two-beep error tone to indicate
that programming was incomplete, and the setting remains as
it was before entering Programming mode.
7 Scan the END bar code.
SR60 Scanner Programmer's Reference Manual
Advertisement
Table of Contents
