10 Seconds
END------------------------------------
Configuring the Half Angle
SR60 Scanner Programmer's Reference Manual
---------
When enabled, the Half Angle feature causes the scanner to scan
with a scan angle that is approximately half the standard setting.
Disabling the feature returns the scanner to the standard scan
width.
Note: By default, the half angle is enabled for the XLR version
and disabled for the SR version.
Note: This feature is not affected when you restore the factory
defaults by scanning the Return to Factory Default Settings
programming bar code. You must manually enable or disable this
feature.
To set the Half Angle options
1 Scan the SET bar code.
2 Scan the Enable bar code to enable half angle, or scan the
Disable bar code to disable half angle.
3 Scan the END bar code.
Chapter 5 — Configuring General Features
149