Table of Contents
Advertisement
Chapter 1 — Learning About Programming the SR60 Scanner
Removing and Replacing an Interface Cable
Reconfiguring the Interface Settings
10
3 Holding the scanner handle and end cap together in one
hand, pull the connector out of the handle end cap to free the
interface cable.
4 Connect the new interface cable at the scanner and rotate the
forked cable retainer to secure it. Tighten the screw to 0.67 to
1.13 Nm (6 to 10 in-lb).
1
3
If you change the interface cable, you may need to reconfigure
the interface settings. For help, see Chapter 2, "Configuring
Interface Settings."
After you reconfigure the interface settings, you should scan a bar
code to verify that the scanner communicates correctly with the
new host system. For sample bar codes, see "Sample Bar Codes"
on page 158.
SR60 Scanner Programmer's Reference Manual
2
Advertisement
Table of Contents
