Table of Contents
Advertisement
External devices
Operating Loewe equipment
Using the remote control for the TV mode of the TV set
Press the TV button, the display above it will light for
approx. 5 seconds.
Using the remote control for a Loewe recorder
Press the REC button, the display above it will light for
approx. 5 seconds.
Using the remote control for a Loewe player
Press the DVD button, the display above it will light for
approx. 5 seconds.
Using the remote control for the radio mode of the TV set
Press the AUDIO button, the display above it will light for
approx. 5 seconds.
As long as a button is pressed, the display of the selected operating mode
lights up (TV – REC – DVD – AUDIO). This allows you to check which op-
erating mode the remote control is set to every time you press a button.
The factory setting of the buttons is described above (see also table in
right hand column). The assignment of the buttons can be changed to
suit the existing accessory devices (see right hand column).
Set unit for sound control function on the remote control
The buttons for the sound control functions Volume (
) and Sound mode/Sound adjustment (
1
interact with the TV at the factory. The unit to be operated can be modified.
Press the TV button and the numeric button at the
same time for minimum 5 seconds. The LED above the
TV button flashes twice.
Function
Buttons
TV + 3
TV + 4
Audio
TV + 5
functions
TV + 6
), Sound on/off (
10
) have been programmed to
30
Unit
Auro/AudioVision/MediaVision 3D
Mediacenter
Loewe TV
Loewe TV with sound projector without
system connection
Setting the remote control for other Loewe devices
You can operate various Loewe devices with the remote control. The
device keys REC – DVD – AUDIO can be reassigned to operate various
Loewe devices.
Press the required device buttons and the Stop button
simultaneously for 5 sec. until the corresponding LED
display flashes twice.
Then enter the two-digit device code from the list below.
The associated LED display flashes twice.
Device
Loewe ViewVision 8106 H
Loewe Viewvision, Centros 21x2
Loewe ViewVision DR + DVB-T
Loewe Auro 2216 PS/8116 DT
Loewe BluTech Vision
Loewe Soundprojector
Loewe TV - Digital radio
Loewe Mediacenter
Loewe BluTech Vision Interactive
HDMI CEC mode
Loewe AudioVision
Loewe Individual Sound Projector SL
Apple IR codes
Apple IR codes (Apple TV-2G)
Loewe Soundbox
Loewe SoundVision
Loewe Air Speaker
Loewe MediaVision 3D
Resetting to factory setting
➠ The codes shown here only apply for direct operation of the acces-
sory device.
➠
For operation of the connected accessory device via the TV set, e.g.
with concealed installation (Code 22), see page 119. The remote
control's signal is transmitted from the TV set to the accessory device
with concealed installation.
➠ The codes that are available may vary depending on the status of the
firmware that the remote control has.
Code
Factory setting
10
12
13
REC
14
15
17
19
AUDIO
20
21
DVD
22
24
25
26
27
28
29
30
35
99
131 -
Advertisement
Table of Contents
