Table of Contents
Advertisement
Initial installation
Setting options for the satellite system
(max. 4 satellites on DiSEqC multiswitch):
Settings
INITIAL INSTALLATION (DVB-S)
DiSEqC
Repeat rate
multiswitch
Control voltage 13/18V
22kHz signal
Toneburst
Proceed
OK
Select and adapt settings for the DiSEqC multi-
switch.
Repeat rate
The refresh rate determines how often a DiSEqC
command is output. A refresh is only necessary with
cascaded systems.
Control
The control voltage controls the switching of the
voltage
polarisation level (horizontal/vertical) in non-DiSEqC
capable components (e.g. control of single LNBs via
DiSEqC multiswitch).
22kHz signal
The 22kHz signal controls the switching between high
and low band in the Band setting. The Position setting
controls the selection of the satellites in non-DiSEqC
capable components.
Toneburst
The Toneburst controls the selection of the satellites in
non-DiSEqC but toneburst capable components with the
Position and Option settings.
OK Proceed
Satellite
INITIAL INSTALLATION (DVB-S)
selection
Satellite selection
Satellite 1
Satellite 2
Satellite 3
Satellite 4
Proceed
OK
Select Satellite 1 ... Satellite 4,
select satellites from list,
OK Proceed.
Network
INITIAL INSTALLATION
selection
Network selection
other network
CanalDigitaal
Proceed
OK
Select network.
If several networks are available over DVB-S, you
can decide which network you want to receive your
channels from.
OK Proceed.
- 26
none
1
2
on
Band
off
Back
Astra1 19,2°E
...
Hot Bird 13°E
Eutelsat W2 16°E
none
Back
OK
Back
LNB
INITIAL INSTALLATION (DVB-S)
frequencies
LNB frequencies
ASTRA1 19,2°E Low band
ASTRA1 19,2°E High band
Hot Bird 13°E Low band
Hot Bird 13°E High band
Eutelsat W2 16°E Low band
Eutelsat W2 16°E High band
Proceed
OK
Set LNB frequencies.
You do not normally need to change the values.
OK Proceed.
(with Setting options for DVB-S reception (continued)
on page 29).
9750 MHz
10600 MHz
9750 MHz
10600 MHz
9750 MHz
10600 MHz
Back
Advertisement
Table of Contents
