Table of Contents
Advertisement
6.18
Link Assembly Removal
6.18.1 Remove tub as in instructions 6.11.
6.18.2 Release clips on side of link assembly to allow the lid of the assembly to hinge
open.
6.18.3 Using a blade screwdriver to wedge out the spigots in the hinge point of the
bracket connecting to the rear of the dishwasher.
6.18.4 With both assembly lid open and the hinge point free the assembly may be
released from the drain hose, fill hose and wiring harnesses (mark on the
harnesses and hoses the location of these to the lid so that when reassembling
they are put back in the same location).
6.18.4 To replace the link assembly bracket, release the wire and hose retaining clip to
free these items, then slide the bracket up and out of rear panel.
6.18.5 Refit in reverse manner.
6.19
Air Pump Removal
Note: This component maybe serviced by two Methods.
6.19.1 Method 1: Remove appropriate tub assembly as per instructions in 6.11.
6.19.2 Method 2: Remove lower kick strip as per instructions in 6.7
6.19.3 Remove the clip pegs from the slide retainers.
6.19.4 Slide the DishDrawer from the cavity to allow servicing from the rear.
6.19.5. Remove the screw securing the rear service panel.
6.19.6 Fit a screwdriver through the hole in the rear service panel and lift or tap the shaft
of the screwdriver up so to disengage the panel from its retainers.
6.19.7 The service procedures from now on are the same for both methods.
6.19.8 Disconnect the air plumbing from the air pump.
6.19.9 The air pump can now be released from the rubber mount (if sliding the rubber
mount off the exhaust valve be careful not to lose the steel core which will fall out
of the exhaust valve. The exhaust valve core is fitted with the rubber end upper
most).
6.19.10 Disconnect the wiring connector from the coil.
6.19.11 Refit in reverse manner. Ensure the pump hangers are correctly located.
- 45 -
Advertisement
Table of Contents
