Table of Contents
Advertisement
4.3
Diagnostic Modes
4.3.1
Temperature Display Mode
During a wash cycle, the current water temperature can be displayed on the LCD instead
of the time remaining. To enter temperature display mode, start a wash cycle as normal.
Initiate a keylock by pushing and holding the Keylock button for 4 seconds.
Once in keylock mode push and hold Start/Pause for 8 seconds to enter temperature
display mode. The temperature is now displayed and the MIN symbol is switched off.
Keylock mode can now be exited.
To cancel temperature display mode, either repeat the above procedure or enter power off
mode by pressing Power. Temperature display mode is automatically cancelled at the
end of a wash program (even in CC mode).
4.3.2
Rinse Aid / Tub-Open Beep Water Pressure Setup Mode
To enter this setup mode, hold the Program and Eco touch switches simultaneously for 5
seconds. Once the setup mode is entered a beep is emitted and the LCD is red with 'HP'
displayed.
Push Power at any time to exit this setup mode.
4.3.3
Rinse Aid Setup
The current rinse aid setting is shown using orange LED's on the touch switch panel. The
amount of rinse aid dispensed into a rinse cycle can be varied to suit the level of hardness
of the local water supply. It is adjusted for 1 - 5 dispenser levels (1 = approx 1ml of rinse
aid, 5 = approx. ounce equivalent of rinse aid).
Push Programme to advance the rinse aid setting. Once the desired setting is achieved,
push Power to exit. The rinse aid index is stored in EE memory, so even with the power
removed, the rinse aid level is retained.
4.3.4
Tub-Open Beep Setup
The beep sequence that occurs when the tub is opened can be turned on or off using the
Keylock button. If the Smiley Face on the LCD is On then the beep sequence will occur
when the tub is Opened. If the Smiley face is Off then no beeps will occur when the tub is
Opened. Push Power to exit when the desired setting has been selected.
The Integrated Model will sound a single beep when turning this option off, while the
actual beep sequence is sounded when turning this option on. The DishDrawer will
default to 'beeps on' if the mains power is removed.
- 17 -
Advertisement
Table of Contents
