Table of Contents
Advertisement
6.20
Exhaust Valve Removal
Note: This component maybe serviced by two Methods.
6.20.1 Method 1: Remove tub assembly as per instructions in 6.11.
6.20.2 Method 2: Remove lower kick strip as per instructions in 6.7.
6.20.3 Remove the clip pegs from the slide retainers.
6.20.4 Slide the DishDrawer from the cavity to allow servicing from the rear.
6.20.5 Remove the screw securing the rear service panel.
6.20.6 Fit a screwdriver through the hole in the rear service panel and lift or tap the shaft
of the screwdriver up so to disengage the panel from its retainers.
6.20.7 The service procedures from now on are the same for both directions.
6.20.8 Lift the exhaust valve up to disengage the mounting from the chassis.
6.20.9 Disconnect the air plumbing from the exhaust valve.
6.20.10 Remove the exhaust valve from the rubber mount (be careful not to lose the steel
core, which will fall out of the exhaust valve. The exhaust valve core is fitted with
the rubber end upper most).
6.20.11 Disconnect the wiring connection from the exhaust valve.
6.20.12 Refit in reverse manner. Ensure the pump hangers are correctly located.
6.21
Water Valve Removal
6.21.1 Remove the lower tub as per instructions in 6.11.
6.21.2 The water valve is located at the rear on the lefthand side.
6.21.3 Disconnect the wiring connections to both solenoids. Release the locking tabs for
the connectors with a blade screwdriver while doing this.
6.21.4 Disconnect the inlet hose connection.
6.21.5 The water valve may now be slid forward off the mounting bracket.
6.21.6 Disconnect the two fill hoses off the valve noting which hose goes to the top and
tub and which goes to the bottom tub.
6.21.7 Refit in reverse manner.
6.22
Flood Switch Removal
6.22.1 Remove the lower tub as per instructions in 6.11
6.22.2 The flood switch is located on the base of the chassis.
6.22.3 Remove the wiring connections to the switch noting each connection location.
6.22.4 The switch is released from the chassis by squeezing together the pins on the
legs of the switch with a fine blade screwdriver.
6.22.5 Refit in reverse manner.
- 46 -
Advertisement
Table of Contents
