8.3
Handle and LCD Display
1.
Remove the drawer front (refer to Section 8.2).
2.
Disconnect the LCD wire harness from the controller.
3.
The handle slides onto the flange at the top of the tub.
Push the handle from the right to the left to release it.
4.
The handle may now be lifted clear by pulling it forwards.
5.
The LCD display is held in place by a wedge with a spring
tab. Without lifting the tab, slide the wedge downwards
using your finger tips to release. The LCD assembly can
now be removed.
6.
The wiring harness can now be unplugged from the LCD
circuit board.
Refit in reverse manner.
8.4
Toe Kick Removal
1.
Partly open the bottom drawer.
2.
Loosen the right and left hand toe kick screws.
3.
Slide the toe kick towards the front of the tub until it comes
off the mounting rails.
Refit in reverse manner.
8.5
Lower Tub Cowling
1.
Remove the lower drawer front (refer to Section 8.2).
2.
Remove the toe kick (refer to Section 8.4).
3.
Release the centre clip as shown and slide the cowling
forward.
Refit in reverse manner.
47
599735A