8.9 Removing the Drain Pump
Remove the product from the joinery.
•
Remove the base panel from the machine, and
•
disconnect the flood switch assembly.
Remove the wiring harness to the drain pump.
•
Depress the clip and rotate the drain pump
•
anticlockwise to release.
When reassembling the drain pump, ensure the
•
lock clip engages to secure the pump.
8.10 Removing the Wash Pump & Heater Assembly
The FC6 model uses a different wash pump, but the
same principle is used to service.
Disconnect and remove the product from the
•
joinery.
Remove the screws securing the base panel from
•
the machine, and disconnect the flood switch
assembly and remove base panel completely.
Sometimes laying the product on it's back is
•
the easiest option to service, however ensure no
hoses are damaged and the floor is covered to
stop any possible damage.
Remove the wiring harness and earth wires to
•
the wash pump and element assembly.
Remove the hose clamps securing the supply
•
hose from the sump and supply hose to the
spray arms.
Pull the hoses off the sump fittings.
•
The wash pump is hung from 2 rubber
•
grommets. To release the wash pump slide the
pump backwards to release.
8 SERVICING THE COMPONENTS
rubber
grommets
D
D
slide
backwards
32