Sleep Mode Activation Time; Setting Autodate Advance - Pitney Bowes DMI100i Operator's Manual

Configuring Your Mailing Machine

Sleep Mode Activation Time

You can set the amount of time the machine waits until entering "sleep mode". When the machine is in
sleep mode, the display is blank and you can't process mail. You awaken the machine by merely
pressing any button on the control panel.
1. Press Options.
2. Press Page Down.
3. Select Time and Timeouts.
4. Select Sleep Mode.
5. Key in the amount of minutes (from 1-240) before the system goes into sleep mode.
6. Select OK. The display returns to Time and Timeouts menu.
7. Press Clear (back arrow key) to return to Options menu.

Setting Autodate Advance

The feature is factory set to 12:00 AM. This means that at 12:00 AM, the system advances the date of
the meter stamp to the new date.
You can set the system to advance the date of the meter stamp at 12:00 PM (afternoon) instead. With
this setting, it allows you to meter mail in the afternoon for the next day's mailing if your mail is sent out
in the morning.
1. Press Options.
2. Press Page Down.
3. Select Time and Timeouts.
4. Select Autodate advance.
5. The following selections appear.
Switch AM/PM – Use the soft key next to this selection to toggle between "AM or "PM". Select
Continue.
Disable – Use the soft key next to this selection to disable the feature and return to using 12:00
AM as the time when the machine advances the date of the meter stamp.
6. The display returns to Time and Timeouts menu.
7. Press Clear (back arrow key) to return to Options menu.
Pitney Bowes Operator Guide September 2023 92