Front Shock Absorber - VESPA GTV 250 i.e. 2008 Service Station Manual

Suspensions
To position roller casings on the pin (pin end in
contact with the internal bottom of the roller cas-
ings) proceed as follows:
- Use the tool with part 20 and 21 fitted to the stem
as indicated in the figure.
- Push the two roller casings with the handgrip until
their bottoms make contact with the pin end.
- Use the specific tool fitted with parts 3 and 4 as
indicated for fitting the spin and push with the
handgrip until the washer is wedged in the swing-
ing hub.
- Remove the spacers, part 17; fill with recommen-
ded grease the area between the steering tube
and the swinging hub, and place the dust guard
rings in that place.
Recommended products
Calcium based grease Calcium grease
Ivory coloured calcium grease; TL 9150 066;
NATO G 460
Refitting
To refit, carry out the removal operations but in reverse order; grease the fifth wheel fittings and tighten
at the specified locking torques
Locking torques (N*m)
Handlebar to steering tube 45 ÷ 50 Upper steering ring nut 35 - 40 Lower steering ring nut 12 -
14

Front shock absorber

SUSP - 206
Vespa GTV 250 i.e.