VESPA GTV 250 i.e. 2008 Service Station Manual page 107

Vespa GTV 250 i.e.
Removing the hub bearings
- Check the state of the bearings being examined
(wear, clearance and noisiness). If faults are de-
tected, do the following.
- Use the specific bearing extractor to remove the
three 15 mm bearings (2 in the crankcase and 1 in
the hub cover)
Specific tooling
001467Y013 Calliper to extract ø 15-mm bear-
ings
Removing the wheel axle bearings
- Take out the clip on the outside of the hub cover.
- Support the hub cover and expel the bearing.
By means of the appropriate tools, remove the oil
seal as in the figure.
Specific tooling
020376Y Adaptor handle
020477Y Adapter 37 mm
020483Y 30-mm guide
020359Y 42 x 47 mm Adaptor
020489Y Hub cover support stud bolt kit
Engine
ENG - 107