Front Shock Absorber - VESPA GTV 125 Service Station Manual

Vespa GTV 125
- Remove the steering tube
- Remove the attachment bracket
- Use the specific tool with the part 1 and operate
the handgrip until removing temporarily the pin and
the Nadella opposite the tool thrusting direction.
- To extract the second Nadella, use the tool with
the part 2, instead of part 1, on opposite side to the
one indicated in the figure.
Specific tooling
020021Y Front suspension service tool
Refitting
To refit, carry out the removal operations but in reverse order; grease the fifth wheel fittings and tighten
at the specified locking torques
Locking torques (N*m)
Handlebar to steering tube 45 ÷ 50 Nm Upper steering ring nut 30 ÷ 40 Lower steering ring nut
8 ÷ 10

Front shock absorber

Removal
- Remove the steering tube
- Remove the shock absorber lower clamps
- Remove the shock absorber upper clamps
Refitting
To refit, carry out the removal operations in reverse order, observing the prescribed tightening torques.
Locking torques (N*m)
shock absorber lower clamp 20 - 27 Nm shock absorber upper clamp 20 ÷ 30
Suspensions
SUSP - 11