VESPA GTV 250 i.e. 2008 Service Station Manual page 134

Engine
- Tighten up the nuts to a second pre-torque of 10
±1 N·m
- Rotate by an angle of 270°
- To carry out the operations described above, fol-
low the tightening sequence in the figure.
- Fit the two screws on the outside of the timing
chain side and tighten them to the specified torque.
N.B.
BEFORE INSTALLING THE HEAD, MAKE SURE THAT THE
LUBRICATION CHANNEL IS CLEAN USING A COM-
PRESSED AIR JET.
Locking torques (N*m)
Timing chain tensioner support screw
- Refit the lower timing chain sprocket wheel on the
crankshaft, with the chamfer facing the insertion
side.
- Loop the timing chain around the sprocket on the
crankshaft.
- Fit the chain tensioner slider from the cylinder
head side.
- Fit the spacer and the screw fastener.
- Tighten the screws to the prescribed torque.
- Fit the pins and rocking levers.
- Lubricate the two rocking levers through the
holes at the top.
- Lubricate the 2 bearings and insert the camshaft
in the cylinder head with the cams corresponding
to the rocking levers.
- Insert the retention plate and tighten the two
screws shown in the figure to the prescribed tor-
que.
- Refit the spacer on the camshaft.
ENG - 134
11 to 13
Vespa GTV 250 i.e.