Suspensions
To position roller casings on the pin (pin end in
contact with the internal bottom of the roller cas-
ings) proceed as follows:
- Use the tool with part 20 and 21 fitted to the stem
as indicated in the figure.
- Push the two roller casings with the handgrip until
their bottoms make contact with the pin end.
- Use the specific tool fitted with parts 3 and 4 as
indicated for fitting the spin and push with the
handgrip until the washer is wedged in the swing-
ing hub.
- Remove the spacers, part 17; fill with recommen-
ded grease the area between the steering tube
and the swinging hub, and place the dust guard
rings in that place.
Recommended products
AGIP GREASE PV2 Ivory smooth-textured,
slightly-stringy anhydrous calcium-base
grease.
TL 9150 066, NATO G 460 symbol
Refitting
To refit, carry out the removal operations but in reverse order; grease the fifth wheel fittings and tighten
at the specified locking torques
Locking torques (N*m)
Handlebar to steering tube 45 ÷ 50 Upper steering ring nut 35 - 40 Lower steering ring nut 12 -
14
Front shock absorber
SUSP - 196
Vespa GTS Super 125 i.e.