Air Filter - VESPA GTV 250 i.e. 2008 Service Station Manual

Maintenance
Replacement
- Remove the oil filler plug «A».
- Unscrew the oil drainage cap «B» and drain out
all the oil.
- Screw in the drainage cap again and fill the hub
with the prescribed oil.
Recommended products
Transmission oil 80W-90 Lubricant for gear-
boxes and transmissions.
SAE 80W-90 API GL-4
Characteristic
Rear hub oil
Capacity approximately 250 cm³
Locking torques (N*m)
Hub oil drain screw
15 - 17 Nm

Air filter

Proceed as follows:
1. unscrew the fixing screw "A".
2. unscrew the nut "B" underneath the casing.
3. remove the left side fairing;
4. remove the helmet compartment;
5. unscrew the fixing screw "C", which can be
reached once the helmet compartment has been
removed;
6. unscrew the screws "D" and remove the air filter
cover.
Extract the filter element, wash it with water and a
neutral detergent, dry it with a clean cloth and
small jets of compressed air, and moisten it with
the recommended oil. Then gently squeeze the fil-
ter element between your hands, allow it to drip
and then refit it. Oil or water deposits in the filter
housing can be cleaned off by removing the two
rubber caps «E».
MAIN - 38
Vespa GTV 250 i.e.