VESPA GTV 250 i.e. 2008 Service Station Manual page 84

Engine from vehicle
This section describes the operations to carry out when removing the engine from the vehicle.
Exhaust assy. Removal
- Remove the left and right fairing and spoiler terminals.
- Remove the Lambda probe from its support and
disconnect it.
Remove the lambda probe cable retainer clamp
from the coolant pipe shown in the photo
- Undo the two exhaust manifold fixings on the
head. To unscrew the nuts that fix the silencer
flange to the head properly, use a jointed wrench
that allows, according to the travel direction, to get
also at the right nut. That is difficult to do with a
traditional straight wrench.
- Undo the three screws that fix the muffler to the
support arm.
- Remove the complete silencer.
ENG VE - 84
Vespa GTV 250 i.e.