Suspensions
Length of the swinging arm tube on the chas-
sis side:
283 ± 0.1 mm
- Lubricate roller casings and the plastic bushings
with grease
- Insert the spacers
- Assemble the two arms with the relative bolt in
the position shown in the picture
- Adjust the bolt as shown in the picture
- Position the chassis side swinging arm with the
most protruding part pointing towards the silent
block side as shown in the picture
Recommended products
Calcium based grease Calcium grease
Ivory coloured calcium grease; TL 9150 066;
NATO G 460
- Make sure the silent bloc is not broken. If it is,
replace the coupling
- Remove the Seeger ring shown in the picture
- Remove the full silent bloc bracket
- Undo the silent bloc ring shown in the picture
SUSP - 214
Vespa GTV 250 i.e.