Table of Contents
Advertisement
Hearthstone Quality Home Heating Products, Inc
instructions du fabricant et conformément à la norme
Manufactured Home Construction and Safety
Standard, Title 24 CFR, Part 3280 aux États-Unis ou à
la norme CAN/CSA-Z240 Série MM, Maisons mobiles
au Canada. Cet appareil doit être utilisé uniquement
avec les types de gaz indiqué s sur la plaque
signalétique.
This appliance is equipped for use at 0 to 2000 feet (0-
610 meters) altitude. (Cet appareil est equipè pour des
altitudes compries entre 0 et 2000 pieds (0-610 m)
seulement.)
Items Required for Installation
External regulator (for propane (LP) only)
LP conversion kit (for propane only))
Piping which complies with local codes
Pipe sealant approved for use with
propane (LP) (resistant to sulfur compounds).
Manual shutoff valve
Sediment trap (see page 18)
Pipe wrench
Phillips head screwdriver
7/16-inch wrench
5/23" (4mm) allen wrench
Other parts as required by local code
Safety Glasses
Gloves
Packing List
1- Champlain 8304 Gas-Fired Heater
1- Pan Burner
1- Owner's Packet (manual, warranty card)
1- LP Conversion Kit
6- Decorative Ceramic Logs (in separate box)
1- Bag of Platinum Bright Embers
Note: Vent kits and components are supplied
separately. Failure to use the venting components
approved by Hearthstone for this appliance will
void your warranty.
Unpacking and Inspection
Hearthstone packages your Champlain to withstand
normal shipment without damage. However, damage
can still occur during transit. Take care to inspect for
damage when unpacking and installing the unit.
DO NOT INSTALL, OR PUT INTO SERVICE, A
DAMAGED OR INCOMPLETE HEATER.
Remove the shrink-wrap and other packaging
materials taking care not to damage the stove's finish.
Inspect the Champlain for visible or concealed
damage. The unit should be square and true. The
sheet metal parts should be smooth and free of bends
and dents. Any enameled cast iron should be free of
chips or cracks. If visible or concealed damage is
found
or
suspected,
instructions.
Always use gloves and eye protection when handling
the decorative ceramic fire logs and burner. Use care
when handling these parts as they are fragile and
subject to damage and breakage if handled roughly.
See the firebox access instructions on page 9. Unpack
and inspect the logs for damage. Inspect the metal
burner as well. Open the other boxes and inspect the
components. If log, burner or any other component
damage is encountered, contact your dealer for a
replacement. Otherwise, set the logs and other
components aside until called for during the
installation.
Dismounting from Pallet
With the accessory boxes removed and set aside,
remove the four lag screws that fasten the unit to the
pallet. Take care not to mar or chip the stove's finish.
Have someone help lift the stove off the pallet, taking
care to avoid damaging components mounted under
the stove.
INSTALLER: Leave this manual with the appliance.
INSTALLATEUR
:
Laissez
l'appareil.
CONSUMER: Retain this manual for future reference.
CONSOMMATEUR : Conservez cette notice
pour consultation ultérieure
Firebox Access
1. Remove top of the stove (lift off). Set carefully
aside on a soft surface.
Figure 2 –Top Removal
2. Release the front panel by lifting up and off of the
stove body. Set aside on a soft surface.
CHAMPLAIN Model 8304
contact
your
dealer
cette
notice
avec
for
6
Advertisement
Table of Contents
