Installer; Nstaller Nformation; Items Required For Installation; Unpacking And Inspection - HearthStone 8120 Owner's Manual And Installation Manual

Hearthstone Quality Home Heating Products, Inc.
I '
NSTALLER S
C
ODES
Adhere to all local codes or, in their absence, the
latest edition of THE NATIONAL FUEL GAS CODE
ANSI Z223.1 (NFPA
Installation Code that can be obtained from:
AMERICAN NATIONAL STANDARDS
INSTITUTE, INC.
1430 BROADWAY
NEW YORK, NY 10018
OR
NATIONAL FIRE PROTECTION ASSOCIATION,
INC.
BATTERY MARCH PARK
QUINCY, MA 02269
A manufactured home (mobile) OEM installation
must conform to the
Construction and Safety Standard, Title 24 CFR,
Part 3280 (U.S.) or Standard for Manufactured
Home Installation, ANSI/NCBCS A225.1 or Standard
for Gas Equipped Recreational Vehicles and mobile
Housing, CSA Z240.4.CAN/SCA Z240 MH (Canada).
(Installer l'appareil selon les codes ou règlements
locaux, ou, en l'absence de tels règlements, selon
les Codes d'installation CAN/CGA-B149.)
I R I
TEMS EQUIRED FOR
* External regulator (for propane/L.P.G. only)
* Piping which complies with local codes
* Pipe sealant approved for use with
propane/L.P.G. (resistant to sulfur compounds)
* Manual shutoff valve
* Sediment trap (see page 18)
* Tee joint
* Pipe wrench
* Phillips head screwdriver
* Flat tip screwdriver
* 7/16-inch wrench
* Other parts as required by local code
*Safety Glasses
*Gloves
P L
ACKING IST
1-Tudor Gas-Fired Heater
1-TEK Burner
2-Decorative TEK Firelogs
4-Refractory Panels
1-Tudor top casting
1-Owner's Manual
I
NFORMATION
54) or CAN/CGA B149
Manufactured Home
NSTALLATION
1-Thermostat
1-40' Thermostat wire
1-Wall thimble Insulation Blanket
1-Warranty Validation Form
Note: Vent kits and components are supplied
separately. Failure to use the venting components
specified by HearthStone QHHP, Inc. will void your
warranty and could risk a fire.
U
NPACKING AND
Unpack and Inspect for Damage
The Tudor is packaged by the manufacturer to
withstand shipment without damage. However,
damage can still occur during transit; so take care
to inspect for damage when unpacking and
installing the unit. If any damage or missing parts
are detected, immediately contact your dealer.
Do not install, or put into service, a damaged
or incomplete heater.
The Tudor requires a pilot shield. This shield
is shipped with the unit. Make sure the sure
the shield is installed over the pilot with the
open end is to the right (when you are facing
the front of the stove)
Inspect the Tudor for visible or concealed damage.
The unit should appear to be square and true. The
sheet metal parts should be smooth and free of
bends and dents. The enameled cast iron should be
free of chips or cracks. If visible or concealed
damage is found or suspected, contact your dealer
for instructions.
With the accessory box removed and set aside,
take care not to mar or chip the enameled legs, if
applicable. Have someone help lift the stove out of
the shipping box and set it into place.
The TEK Burner and TEK Firelogs supplied with the
Tudor are contained in the accessory box. The
inner refractory panels are wrapped and are in the
firebox. Always use great care when handling the
decorative fire logs and inner panels, as they are
fragile and subject to damage and breakage if
handled roughly. If a broken log or panel is
encountered, contact your dealer for replacements.
Otherwise, set the logs and panels aside until called
for during the installation.
7
Tudor Model #8120
I
NSPECTION