Jumper Settings - Advantech MIC-3399 User Manual

1.4.1

Jumper Settings

1.4.1.1 Clear CMOS (JCMOS1)
This jumper is used to erase CMOS data. Follow the procedures below to clear the
CMOS.
1. Power off the system.
2. Close JCMOS1 Pins 1 and 2 for about 3 seconds.
3. Then close JCMOS1 Pins 2 and 3, as per the Normal setting.
4. Power on the system. The BIOS will be restored to the default settings.
Table 1.6: JCMOS1 Clear RTC
Status Function
Closed 1-2 Clear RTC
Closed 2-3 Normal
1.4.1.2 Rear LVDS Setting (JLVDS1)
This jumper is used to configure the LVDS power settings.
Table 1.7: JLVDS1 Settings
Status Function
Closed 1-2 LVDS for 3.3V LVDS panel
Closed 2-3 LVDS for 5V LVDS panel
JCMOS1 Closed 1-2
JLVDS1 Closed 1-2
9
Note
[default]
JCMOS1 Closed 2-3
Note
[default]
JLVDS1 Closed 2-3
MIC-3399 User Manual