xFusion Digital Technologies FusionServer 2288H V7 Manual page 53

FusionServer 2288H V7 Server
Technical White Paper
Configuratio
n
● a: I/O module 1 (2 x 2.5") is configured with rear 2 x 2.5" drives and a PCIe riser
● b: NVMe drives are supported when CPU 2 is configured. A single-CPU server
● For details about the optional components, consult the local sales
Drive Numbering
The drive numbers identified by the RAID controller card vary depending on the
cabling of the RAID controller card. This section uses the drive numbers identified by
a RAID controller card that adopts the default cabling described in "Internal Cabling"
in the FusionServer 2288H V7 Server Maintenance and Service Guide.
●
Issue 02 (2023-05-25)
Front Drive
module.
does not support NVMe drives.
representative or see "OS and Parts Compatibility" in the
Checker.
NO TICE
Drive numbering of the 12 x 3.5" drive pass-through configuration 1 in
5-17
Figure 5-35 Drive numbering (I/O module 1 configured with 2.5" drives)
Figure 5-36 Drive numbering (I/O module 1 configured with 3.5" drives)
Copyright © xFusion Digital Technologies Co., Ltd.
Rear Drive Built-in Drive
5 Hardware Description
Drive
Management
Mode
Compatibility
Table
46