Table of Contents
Advertisement
3. Connect the L, N, and PE harness connectors to the corresponding terminals.
4. Tighten the screws at each terminal.
5. Route the power cable through the slot provided on the terminal block cover. To avoid pinching
the power cable, ensure the cable and rubber grommet are placed inside the cover cutout.
CineLife+ RGB PLF Installation and Setup Guide–CP4440-RGB, CP4450-RGB
020-103072-04 Rev. 1 (03-2021)
Copyright
©
2021 Christie Digital Systems USA, Inc. All rights reserved.
Installing and setting up
38
Advertisement
Table of Contents
