Table of Contents
Advertisement
Using the FH-816 Holder for 16-mm Film Strips
The FH-835S is used when scanning strips of 16-mm film up to twenty frames in length. Up to three
film strips can be placed in the holder at a time.
Inser t your fingers into the holes in the lower por tion holder to unlatch the hooks holding the upper
cover in place, then open the holder.
Upper cover
Hooks (× 2)
Place the film to be scanned in the holder with the matte emulsion surface down (the shiny surface up)
and the frames aligned with the apertures in the lower por tion of the holder. Close the upper cover so
that the latches click into place.
Cautions
Use only one type of film at a time. Do not place negative and positive film in the holder at the same time.
To avoid damaging the film, use a blower to remove dust and lint from the film and holder. Leaving dust, lint,
or other foreign objects on the film or holder dur ing scanning could result in reduced image quality or in
damage to the film.
95
Advertisement
Table of Contents
