Table of Contents
Advertisement
Using the FH-8G1 Medical Holder
The FH-835M is used when scanning 26 mm × 76 mm glass microscope slides containing prepared
tissue samples. Up to three slides can be placed in the holder at a time. Slides must conform to the
following specifications:
Total thickness:
Dimensions (slide): width 26 mm, length 76 mm, thickness 0.8–1.5 mm
Dimensions (cover): width 25 mm or less, length 60 mm or less, thickness 0.18 mm or less
Insert the slides under the clips. Slides should be inser ted between the guides, with the cover facing
upwards. Stop when the slide comes into contact with the base of the clips.
Cautions
Do not use force when inserting slides. Failure to observe this precaution could damage the clips that hold
the mounts in place. Should you encounter resistance, try inserting the slides at a slight angle.
Be sure to insert slides between the guides. The scanner may not be able to adjust focus correctly if slides are
placed on top of the guides. Inserting the slides on top of the guides could also damage the c lips that hold
the mounts in place.
Do not leave the slides in the holder for extended periods, as it may deform the clips that hold the slide
mounts in place.
Use a blower to remove dust and lint from the slides and holder. Leaving dust, lint, or other foreign objects on
the slides or holder during scanning could result in reduced image quality.
Do not use Digital ICE3 when scanning microscope slides. When Digital ICE3 is used, noise may appear in
the preview image or final scan.
The FH-8G1 can also be used to scan mounted 35-mm film. You should not, however, place microscope slides
and 35-mm slides in the holder at the same time.
100
2 mm or less
Clips
Advertisement
Table of Contents
