Installing a drive blank
Prerequisites
1. Follow the safety guidelines listed in the
2. If installed,
remove the front
Steps
Slide the drive blank into the drive slot until the release button clicks into place.
Figure 34. Installing a drive blank
Next steps
If removed,
install the front
Optional optical drive
This is a service technician replaceable part only.
Removing the optical drive
The procedure for removing an optical drive and optical drive blank is the same.
Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3. If installed,
remove the front
Steps
1. Disconnect the power and data cables from the connectors on the optical drive.
NOTE:
While you remove the cable, be sure to take note of its routing.
2. To release the optical drive, press the release tab and push the drive towards the front of the system.
3. Slide the optical drive out of the system.
44
Installing and removing system components
Safety
instructions.
bezel.
bezel.
Safety
instructions.
Before working inside your
bezel.
system.