Adjusting The Position Of The Media Detection Sensor; Confirming The Position Of The Transmissive Sensor (Fixed) - Toshiba BV410T-GS02-QM-S Owner's Manual

Adjusting the position of the media detection sensor

0.
To ensure that the media are fed correctly, the printer is equipped with two types of media detection sensor: reflective
sensor (movable), which detects the black marks printed on the back side of media, and transmissive sensor (fixed),
which detects the gap between labels.
Adjust the position of the reflective sensor to match the position of the black mark. If it is not adjusted to a correct
position, the printer cannot issue the media because it cannot detect the rear end of the media, displaying the "PAPER
JAM ****" message and resulting in an error. If you changed the media type or quality, adjust the sensitivity of the
media sensor.
For details, refer to "Key Operation Specification".
Immediately after printing, do not touch the print head or its surrounding area.
This could cause burns.

Confirming the position of the transmissive sensor (fixed)

The transmissive sensor is fixed at a position [2] 6.27 mm (0.25") to the right of the media center [1].
6.27 mm
(0.25")
[ 1 ]

58 Adjusting the position of the media detection sensor

[ 2 ]