A1.3.2 Detection Area Of The Transmissive Sensor - Toshiba B-852-TS12-QP Owner's Manual

APPENDIX 1 SPECIFICATIONS
A1.3.1 Media Type (Cont.)
Item
Minimum media pitch
Label length
Width including backing paper
Gap length
Black mark length (Tag paper)
Effective print width
Print speed up/slow down area
Black mark length (Label)
Max. print length
Maximum effective length for on the fly issue
Max. outer roll diameter
Label + backing paper
Thickness
Tag
NOTES:
1. To ensure print quality and print head life use only TOSHIBA TEC specified media.
2. When using the cutter ensure that label length
(i.e. label pitch should be greater than 38 mm.)
3. When marking black marks on label rolls, the following requirements must be satisfied.
When the gap length is less than 4 mm:
The black mark length should be longer than the gap length.
When the gap length is 4 mm or more:
The black mark should not overlap the gap for more than 4 mm and the following label.
4. "On the fly issue" means that the printer can feed and print without stopping between labels.
A1.3.2 Detection Area of the Transmissive Sensor
The transmissive sensor is movable from the center to the left edge of media.
The transmissive sensor detects a gap between labels, as illustrated below.
(Min. 6.0 mm when using
the cutter module.)
Label dispensing mode
Area to be detected.
Sensor position
Min. 2.0 mm
Min. 12 mm
Batch mode
15.0
Min. 12.5
100.0- 242.0
2.5 – 20.0
Refer to NOTE 3 below.
plus inter-label gap length
Center of media
Label
Gap
Label
Sensor is movable
within this range.
EA1- 3
ENGLISH VERSION EO1-33028
[Unit: mm]
Cut mode
Label: 38.0
Tag: 25.4
Min. 32.0
100.0 – 235.0
6.0 – 20.0
2.0 – 10.0
216.8±0.2
1.0
640.0
320.0
φ230
0.13 – 0.18
0.08 – 0.18
exceeds 38 mm.
Print side
Media feed direction
A1.3 Media