Table of Contents
Advertisement
2.Printer Setup
When passing the media through the outer roll paper hooks [1], be careful not to create wrinkles or damage it in
any way. Using a media with wrinkles or other damage could cause a print failure.
Set the right and left levers of the platen unit holder in accordance with the type of the media
6
loaded. (Label: Tilt the lever forward, Tag: Tilt the lever backward.)
TAG
LABEL
When tags whose width is less than 50.8 mm (2") are used, set the levers to the [LABEL] side.
Lower the top cover gently, press on the front of the top cover with both hands until it "snaps"
7
into place to make sure that it is closed securely.
Press the [FEED] button to confirm that the media can be cut correctly.
8
44 Loading the media
Advertisement
Table of Contents
