Toshiba BV410T-GS02-QM-S Owner's Manual page 50

2.Printer Setup
Adjust the position of the roll media so that the roll media will be centered on the media shaft.
4 Insert the end of the media into the media slot.
While pulling each of the right and left lock release portions [1] in the arrow direction, fully open
5
the top cover [2].
[ 1 ]
Pull up the paper damper (bottom) [1] to unlock it.
Extend the media holder [1] and the media guide [2] to the right and left by aligning them to the
6
paper width. Pass the media under the media holder [1] and the media guide [2], and pull it to the
media outlet.
[ 2 ]
By aligning the media holder and the media guide to the paper with, adjust them so that there is
7
no gap between them and the media.
50 Loading the media
[ 2 ]
[ 1 ]
[ 1 ]
[ 1 ]
[ 2 ]