Toshiba BV410T-GS02-QM-S Owner's Manual page 95

5.Appendix
1. Fit the left side [1] of the ribbon spooler inserted into the roll in the guide wheel [2].
2. Fit the right side [3] of the ribbon spooler in the guide hole [4].
[ 2 ] [ 1 ]
Mount the take-up side roll of the ribbon on the guide.
10
1. Fit the left side [1] of the ribbon spooler inserted into the roll in the guide wheel [2].
2. Fit the right side [3] of the ribbon spooler in the guide hole [4].
[ 2 ] [ 1 ]
Rotate the ribbon spooler in the upward direction to remove any slack in the ribbon.
11
 Any slack in the ribbon could cause poor print quality. After removing the slack in the ribbon, turn the ribbon
spooler two more times to ensure that all the slack in the ribbon is removed.
 The portion of the ribbon that you touched when loading the ribbon may have poor printing quality. Thus,
rotate the ribbon spooler until the portion you touched passes the print head passing position.
[ 3 ] [ 4 ]
[ 3 ] [ 4 ]
Replacing the supplies 95