Toshiba BV410T-GS02-QM-S Owner's Manual page 87

5.Appendix
7. Printing on the RFID tag-encapsulated portion (chip/antenna portion)
The surface of the portion of the media in which the RFID tag is encapsulated is uneven, and printing in this
portion could cause the print around the uneven portion to be discontinuous. In the area of 5 mm (0.20") before
and after the RFID tag-encapsulated portion and on both lateral sides of the portion, in particular, printing is
likely to be blurred and discontinuous. These areas are outside the printing-guaranteed area. (Refer to the figure
below.)
* The degree of blur or discontinuity differs depending on the height of the RFID tag (chip/antenna) encapsulated.
[ 1 ]
1. Area outside the printing-guaranteed area
2. RFID tag-encapsulated portion
A: Media feed direction
8. Ambient temperature
The performance of the wireless system changes depending on the ambient temperature. If the ambient
temperature changes from the one at the time of making the RFID settings, writing to data to the RFID tag may
fail.
9. Peel-off issuance
If you perform the peel-off issuance of RFID labels, the peel-off performance varies depending on the glue of the
label used, tag, and base. Depending on the media, peel-off issuance cannot be performed normally.
10. Notes on using short-pitch media
If media with a short pitch (RFID tag placement interval) are used, there are cases in which even if an attempt is
made to write data to the tag to which it should be written, the data is written to a neighboring tag. The position
at which data can be written differs depending on the tag type, and it is necessary to conduct measurement by
using actual tags so that data cannot be written to a neighboring tag. To diagnose read/write positions, use the
BCP RFID analyze tool. For details, contact your service representative.
11. Defective RFID tag
RFID tag paper may contain defective tags before shipment from the manufacturer. The defect rate differs
depending on the tag type, the method of manufacturing the RFID tag paper, and other factors. It is necessary to
have the RFID tag paper manufacturer remove defective tags in the manufacture process or to have them make
defective tags identifiable by, for example, placing marks on defective tags and confirm the identification
method.
12. Automatic media setting
If issuing RFID tag paper, do not use the automatic media setting function. Set [CALIBRATE] in the parameter
setting to [OFF].
For details, refer to "Key Operation Specification".
5 mm (0.20")
[ 2 ]
5 mm (0.20")
[ 1 ]
[ A ]
Specifications 87