PeakTech 1245 Operation Manual page 149

Digital oscilloscopes
Hide thumbs Also See for 1245:
Table of Contents

Advertisement

Available languages

Available languages

Set the network parameters of the oscilloscope.
In the oscilloscope, press the Utility button and press H1 button, turn the M knob to select the LAN Set; press
the H2 button, the set menu is displayed on the right. Set the IP and the Port to the same value as the
"Ports-settings" in the software in step (3). Press the F5 button, it prompts "reset to update the config". After
resetting the oscilloscope, if you can get data normally in the oscilloscope software, the connection is
successful.
How to connect with the computer through a router:
1.
Connection. Use a LAN line to connect the oscilloscope with a router, the LAN port of the oscilloscope is
in the right side panel; the computer should be connected to the router too.
2.
Set the network parameters of the computer. Since the oscilloscope can not support obtaining an IP
address automatically, you should assign a static IP address. The Default gateway should be set
according to the router. Here we set the IP address to 192.168.1.71, Subnet mask is 255.255.255.0,
Default gateway is 192.168.1.1.
Fig. 63
-148-

Advertisement

Table of Contents
loading

This manual is also suitable for:

12401255126012701275

Table of Contents