PeakTech 1245 Operation Manual page 147

27.2.6. LAN Set
Using the LAN port, the oscilloscope can be connected with a computer directly, or through the router to
connect. The network parameters can be set in the menu below.
Press the Utility button and turn the M knob to select the LAN Set to go to the following menu.
The description of LAN Set menu is shown as the follows:
Function Menu Setting
IP
Port
Set Netgate
Phy addr
Set OK
How to connect with a computer directly:
1. Connection. Plug in the LAN line to the LAN port in the right side panel of the oscilloscope; plug the other
end into the interface of the computer.
2. Set the network parameters of the computer. Since the oscilloscope can not support obtaining an IP
address automatically, you should assign a static IP address. Here we set the IP address to 192.168.1.71,
Subnet mask is 255.255.255.0.
Fig. 60 LAN Set menu
Description
Press F1 button to switch between each byte, turn the M knob to change
value (0 ~ 255)
Turn the M knob to change value (0 ~ 4000)
Press F3 button to switch between each byte, turn the M knob to change
value (0 ~ 255)
Press F4 button to switch between each byte, turn the M knob to change
value (0 ~ FF)
Press F5 button to confirm, prompt "reset to update the config"
-146-