Table of Contents
Advertisement
5
Recovery
Create an Image on the New Recovery Partition
After replacing a damaged/defective hard drive and recovering the image
from the recovery DVD, you should create an image on the recovery
partition.
Create an image on the new recovery partition
Step
1 Insert the supplied bootable CD into the
2 Exit from Windows
a START
b SHUTDOWN
c select RESTART on Windows
3 Press (A) "Press A to create an image on
4 Press (C) to continue.
5 Remove the bootable CD.
6 Restart the computer by pressing the red
7 Open Windows Explorer
64
appropriate drive.
®
Recovery Partition".
RESET button on the front panel.
®
to verify that the
recovery partition exists. See Recovery (D).
Notes
•
The bootable CD part number is E5500-10010
and the content is Revision A.00.01 or higher.
•
The system restarts with the bootable CD
installed. Upon boot up A DOS
appears, entitled "Backup Menu".
®
•
shutdown.
•
•
Symantec Ghost
an image on the recovery partition from the
primary partition. This image includes hidden
files. This process takes about 4-5 minutes.
•
•
Windows
•
Two large files are visible, CDR00001.GHO
and CDR00001.GHS. The total of these two
files is about 4 GBytes.
®
screen
®
now takes over to create
®
launches
E5505A Installation Guide
Advertisement
Table of Contents
