Agilent Technologies N5502A Installation Manual page 70

Phase noise measurement system
Table of Contents

Advertisement

Removing the Hard Disk Drive
1
2
Figure 38 Hard Disk Drive Assembly
Installing the Hard Disk Drive
1
2
If the hard disk drive is not locked, the computer will not boot up.
N O T E
E5505A Installation Guide
Turn off the computer.
To remove the existing removable hard disk drive assembly from the
computer, unlock the removable hard disk drive lock, carefully pull the
ejector lever, and slide the removable hard disk drive assembly out of
the slot. Refer to
Figure
Insert the alternate hard disk drive assembly into the slot on the
computer with the ejector lever pulled up (See
assembly with the ejector lever pushed down (See
it into place using the key.
To turn the computer on, press the power switch.
38.
Recovery
Figure
39). Secure the
Figure
40), and lock
5
69

Advertisement

Table of Contents
loading

Table of Contents