Precautions For Transport And Handling; Labels - JAKA C Series Hardware User Manual

2. Manual brake release: After removing several screws used for fixed joint lid, remove the joint lid and press
the slider in the small electromagnet (as shown in the figure below) to manually release the brake.
Warning:
1. Forced manual movement of the robot arm is limited to emergencies and may lead to joint damage. It should
not be used as a routine operation.
2. If the brake is released manually, the joint of the robot may move under gravity, so it is necessary to effectively
support the robot and tools or workpieces installed on the robot before manually releasing the brake.

1.11 Precautions for Transport and Handling

The original packaging needs to be fixed during transportation to ensure that the robot is stable and dry.
When the robot is hoisted, corresponding measures should be taken for positioning to avoid damage caused
by accidental movement.
When moving the robot from its packaging to the installation position, hold the robot until all the screws on the
robot base are tightened.
Warning:
1. Ensure that the back or other body parts of operators are not overloaded when the equipment is hoisted.
Use appropriate hoisting equipment. JAKA is not responsible for damage incurred during the transport of the
equipment.
2. Ensure that installation instructions are strictly followed when the robot is installed.

1.12 Labels

The following labels are safety warning labels and product label on the robot and the control cabinet. During
the operation, be sure to follow the instructions and warnings on the labels to ensure safety. Do not remove the
labels at will and control stick labeled parts or units and their surrounding area with caution to avoid damage to
the labels. Labels are only for reference.
File Version: 3.2
Figure1-1 Manual brake release
11 / 62 JAKA C Series Hardware User Manual