Fig. 32 Mounting Card Holder; Fig. 33 Mounting Housing Cover - Beckhoff C5240 Manual

Maintenance
3. Fasten the card holder again with the six M4 screws (section C).
4. For each plug-in card, press down the associated plastic element of the card holder until the plug-in card
is firmly seated in its slot.
ð You have mounted the card holder.
A
Fig. 32: Mounting card holder
To mount the housing cover to the PC, follow the steps below, shown in Figure 33:
1. Place the housing cover on the housing 1 cm before the target position (section A).
2. Slide the housing cover 1 cm forward (section B).
3. Fasten the cover with the two M4 screws (section C).
ð You have mounted the housing cover again.
A
C
Fig. 33: Mounting housing cover
40
B
Version: 3.0
C
B
C5240