Access To Device Components; Fig. 31 Access Device Components - Beckhoff C5240 Manual

7.2.1

Access to device components

To be able to replace certain device components, you must first gain access to the interior of the industrial
PC.
To do this, follow the steps below as shown in Figure 31:
1. Loosen and remove the two M4 screws from the housing cover (section A).
2. Push the housing cover 1 cm backwards (section B).
3. Remove the housing cover upwards (section C).
4. Loosen and remove the six M4 screws from the card holder (section D).
5. Lift the card holder on the right side (section E).
6. Remove the card holder to the right of the device (section F).
ð You now have access to the interior of the industrial PC.
A
C
E
Fig. 31: Access device components
To reinstall the card holder afterwards, follow the steps below, shown in Figure 32:
1. Release all plastic elements of the card holder (section A).
2. Insert the holder back into the industrial PC with the left side first (section B).
C5240
B
D
F
Version: 3.0
Maintenance
39