Table of Contents
Advertisement
installation
Gi29 Hearth Trim Installation (Part # 311-941 )
Hearth Trim Installation - Trimming to Height
1. Remove the lower section of hearth trim by pulling evenly from both
sides.
2. If using a grinder (recommended): trim the lower section to height
referring to the installation table for the amount to remove.
2a. If using snips:
• Cut horizontally, refering to the installation table for the amount
to remove.
• Cut vertically along the corner to meet the previous cut.
• Cut horizontally across the front face.
• Repeat the process on the opposite side.
54
| Gi29 Direct Vent Gas Insert
920-483
TRIMMING TO HEIGHT
2
1
2
3
1
3
1
3. Slide the lower section back into the clips on the rear of the upper
section.
Installation Table
Required install height
Height to cut off lower section
2
6" (Max)
None
5 1/2"
1/2"
5"
1"
4 1/2"
1 1/2"
4"
2"
3 1/2"
2 1/2"
3"
3"
2 1/2"
3 1/2"
2" (Min)
4"
1
3
12.17.21
Advertisement
Table of Contents
