Optional Hearth Trim Installation - Regency Fireplace Products L390E-NG Installation, Commissioning And Servicing Instructions

installation
Hearth Trim is an option that can be used to fi nish off the installation when the bottom of the fi replace is higher than the hearth or to raise the fi replace.
1) For units L390E/HZI390E/L540E/HZI540E–remove 4 screws in
locations shown below to remove outer faceplate.
Diagram 1–Screw Locations
1a) For units U31/U32/E21/E33–remove outer faceplate by lifting up
and off backing plate.
Diagram 2–Lift off Front Faceplate
**If no holes are present on the backing plate, proceed to the Step 3.
2) If screw holes are present on backing plate, secure the hearth trim
to backing place with 2 screws on each side.
Hearth Trim
Diagram 3–Hearth Trim Secured to Backing Plate
919-094
36
LOW PROFILE HEARTH TRIM
OPTIONAL HEARTH TRIM
OPTIONAL HEARTH TRIm
INSTALLATION
INSTALLATION
** If no screw holes are present.
3) Remove backing plate by removing 4 screws–lay down fl at.
Diagram 4–Backing Plate Removal Units L390E/HZI390E/L540E/
4) Secure hearth trim to backing plate with a clip on each side as
shown in Diagram 6. Ensure the hearth trim is evenly space on
either side of the backing plate.
Clip
5) Reinstall backing plate.
6) Reinstall outer faceplate.
1
HZI540E
Diagram 5–Backing Plate Removal Units U31/U32/E21/E33
Diagram 6–Hearth Trim Clip
Hearth Trim
11/30/11
L390E / HZI390E Direct Vent Gas Insert