Table of Contents
Advertisement
1. INTRODUCTION
This manual contains information needed to configure the hardware and software of the ADL300 series drive (Release
3.0 and later) so that they can work in a lift system in which the various control devices communicate via a CANopen Lift
network, i.e., based on DS417 profile.
Use of the CANopen Lift requires an ADL300 version with CAN port (ADL300B-xxxx-KBL-F-4-C-yyyy
Note:
and ADL300A-xxxx-KBL-4-C-yyyy).
Communication via DS417 profile is in MdPlc environment and is therefore considered an application for all purposes.
The application is supported in all control modes provided by the drive.
The application has to be loaded via the procedure described in chapter 10.
This manual is specifically for the CANopen Lift application; for all other configurations, see the manuals ADL300 FP
"Description of functions and Parameter list" and ADL300 QS "Quick Start Guide to installation".
ADL300 CiA® 417- Description of functions and parameter list
Page 4 of 46
Advertisement
Table of Contents
