WEG ADL300 User Manual page 27

Stop sequence:
1 When zero speed is reached, the stop command is enabled.
2 After Speed 0 Delay PAR 11080, the command is given to close brakes 1-2.
3 After the time in Brake close delay, has lapsed, and if you want the current to be lowered on the ramp, wait for the
current limit to be brought to zero, and then the Enable lift signals, arrival zone signals, and DC braking signals are
lowered.
4 After the time set in Contactor open delay has lapsed, the system checks that zero current is delivered before
commanding opening of the contactors.
IT IS ESSENTIAL to guarantee that whenever the drive goes into alarm or is disabled, the drive must stop and the
command must be given to open the contactors.
Menu Par Description
5.3.1 11000 Landing Zone
This parameter defines the start of the landing zone. The distance from the start of the landing zone to floor level is
expressed in meters.
Menu Par Description
5.3.2 11016
Final Adjust
This parameter defines an offset that is added to the arrival point calculated by the protocol.
Menu Par Description
5.3.3 11018 Final Adjustment
When this parameter is ON, movement in the landing zone is rectilinear; when OFF, the arrival curve calculated by the
protocol is used.
Menu Par Description
5.3.4 11060 Seq start mode
Setting the contactor command sequence start mode.
0 Start FW/RW
1 Enable
By setting 0 you can activate the contactor sequences without the Enable command (Enable is required only for motor
operation). The Enable signal can be given by an auxiliary contact of the output contactors.
By setting 1 you can activate the contactor sequences only if the Enable command is ON.
ADL300 CiA® 417- Description of functions and parameter list
UM
m
Decel Phase
Landing Zone
UM
UM
UM
Type FB BIT Def
FLOAT 0
Floor Level
Type FB BIT Def
FLOAT OFF
Type FB BIT Def
BIT OFF
Type FB BIT Def
ENUM 0
Min Max Acc
*** *** RW
Min Max Acc
*** *** RW
Min Max Acc
*** *** RW
Min Max Acc
0 1 RW
Page 27 of 46
Mod
FVS
Mod
FVS
Mod
FVS
Mod
FVS