WEG ADL300 User Manual page 25

Menu Par Description
5.2.7 11054 Percent acc factor
Setting the acceleration coefficient multiplier.
If set to 100, the ramp uses the coefficients entered in the parameters.
If set to less than 100, the lift will tend to accelerate in a larger space.
If set to more than 100, the lift will tend to accelerate in a smaller space.
Menu Par Description
Percent dec factor
5.2.8 11056
Setting the deceleration coefficient multiplier.
If set to 100, the ramp uses the coefficients entered in the parameters.
If set to less than 100, the lift will tend to decelerate in a larger space.
If set to more than 100, the lift will tend to decelerate in a smaller space.
Menu Par Description
5.2.9 11258
Max End Jerk
This is the maximum configurable jerk value during deceleration. Parameter 11256 Comp Enable must be enabled.
ADL300 CiA® 417- Description of functions and parameter list
UM Type FB BIT
Perc FLOAT
UM Type FB BIT
Perc FLOAT
UM Type FB BIT
m/s3 FLOAT
Def Min Max
100.0 0.0 1000.0
Def Min Max
100.0 0.0 1000.0
Def Min Max
2 0.004 30.000
Acc Mod
RW FVS
Acc Mod
RW FVS
Acc Mod
RW FVS
Page 25 of 46