Custom Pitch; Selecting A Custom Pitch - JUKI PLC-2710V Instruction Manual

9-4. Custom pitch

Step1
1mm 3 stitches
Step2
2mm 2 stitches
Step3
3mm 1 stitches
Step4
1.5mm 2 stitches
Step1
1mm 3 stitches
<Figure: Example of the custom pitch>

9-4-1. Selecting a custom pitch

Select an already-created custom pitch.
Custom pitch can be used fro pattern sewing, reverse-feed stitching at the beginning of sewing and re-
verse-feed stitching at the end of sewing. In this section, application of a custom pitch to a sewing pattern is
described as an example.
① Displaying the stitch length input screen
❶
<Sewing screen (Maintenance personnel mode)>
A pattern design consisting of two or more different stitch-
length groups (10 steps at the maximum) can be registered
as a custom pitch. As many as 20 different custom pitches
can be registered.
As many as 100 stitches of the same stitch length can be set
in one step.
One cycle of
* This operation is to be carried out under the mainte-
custom pitch
pattern
Next cycle
nance personnel mode.
1. With some combinations of stitch length, direction
of feed and sewing speed, the sewing machine may
fail to finish a sewing pattern exactly according to
the settings.
2. Needle cannot be entered to the same needle entry
point when the stitch length is set to 0.0 mm.
1) Press
the maintenance personnel mode.
The "sewing data edit screen" is displayed.
– 126 –
❶ on the sewing screen under