Table of Contents
Advertisement
4-6. Adjusting the alternating vertical movement amount
1)
Press
. Select "1. Memory switch" from the menu list.
2)
Select "K395 Maximum alternating vertical movement amount" from "1. Display all".
3)
Set the amount of the alternating vertical movement of the walking foot and presser foot.
(Factory-set value: 6.5)
4)
Confirm your entry by pressing
When cancelling the limit, the presser foot and walking foot may interfere with each other. The press-
er foot may also interfere with the needle bar in the case of using a heavy-weight material. Check to
make sure that there is no interference between the above before using the sewing machine.
❶ A
❷
❸
❶
❶ . Then, the sewing screen is displayed.
The alternating vertical movement amount is dis-
played in section A on the operation panel.
(Example of display : 2.0 mm)
[How to adjust]
1) When
vertical movement amount input screen is
displayed.
2) Change the alternating vertical movement
amount by pressing numeric keypad ❷ . (Input
unit: 0.5 mm; Input range: 0.5 to 9.0 mm)
3) Confirm your entry by pressing
Then, the sewing screen is displayed.
[Setting the amount of the alternating vertical
movement of the walking foot and presser
foot]
The amount of the alternating vertical movement of
the walking foot and presser foot has been facto-
ry-limited to 6.5 mm at the time of shipment. If you
want to cancel the limit, change the setting of the
following item as described below.
– 29 –
❶ is pressed, the alternating
❸ .
Advertisement
Table of Contents
